Metrology and Calibration Program Cancelled NPD and Created New Technical Standard
March 05, 2018
2-minute read
At the recommendation of the NASA Metrology and Calibration (MetCal) Program, the Office of Safety and Mission Assurance cancelled NPD 8730.1, Metrology and Calibration and transferred the content to a new NASA standard, NASA-STD-8739.12, Metrology and Calibration, which went into effect Jan. 23, 2018. NPD 8730.5, NASA Quality Assurance Program Policy will carry the remaining MetCal policy language that was not transferred to NASA-STD-8739.12.
Read More
NASA Confirms Accuracy of Voltage Calibration Standard
April 07, 2015
3-minute read
The NASA Metrology and Calibration program’s Programmable Josephson Voltage Standard (PJVS) recently was routed to three other government organizations as part of an Inter-Laboratory Comparison (ILC). The PJVS is the most accurate Direct Current (DC) voltage calibration standard available. The comparison validated that NASA’s PJVS and the Josephson voltage standards at those locations are working properly and providing accurate measurements.
Read More
Metrology and Calibration Program’s Equipment Repurposing Efforts Save Millions
October 06, 2014
4-minute read
For the past three years, NASA’s Metrology and Calibration Program Office has been repurposing measuring and test equipment previously used to support the Shuttle Program at Kennedy Space Center, resulting in close to $2 million in cost avoidance to date.
Read More
Checking In With the Metrology and Calibration Working Group
November 01, 2013
3-minute read
The Metrology and Calibration Working Group held its annual meeting Aug. 13 through 15 at NASA’s Glenn Research Center. The annual meeting is an opportunity for members of the metrology and calibration community to meet face-to-face.
Read More