Ruminations, Myths and Unreliable Facts
November 17, 2014
1-minute read
Henry Livingston, an engineering fellow and technical director at BAE Systems Electronic Systems, is in the process of writing a series of essays — "Ruminations, Myths and Unreliable Facts" — that provides insight on the serious and growing issue of counterfeit parts. The Introduction and Chapters 1-2 are now available on his website.
Read More
OSMA Holds Quality Benchmarking Meeting at Ball Aerospace
November 17, 2014
4-minute read
NASA’s Office of Safety and Mission Assurance held a quality benchmarking visit at Ball Aerospace and Technologies Corp. in Boulder, Colorado, Sept. 23. It was the third in a series of benchmarking meetings intended to enhance quality across NASA and the space industry.
Read More
Metrology and Calibration Program’s Equipment Repurposing Efforts Save Millions
October 06, 2014
4-minute read
For the past three years, NASA’s Metrology and Calibration Program Office has been repurposing measuring and test equipment previously used to support the Shuttle Program at Kennedy Space Center, resulting in close to $2 million in cost avoidance to date.
Read More
New EEE Parts Bulletin
August 22, 2014
1-minute read
The EEE Parts Bulletin for June-August 2014 is now available.
Read More
Workmanship Program Provides Online FAQs and Status Updates
August 15, 2014
2-minute read
NASA provides answers to frequently asked questions about the NASA Workmanship Program and associated standards.
Read More
DoD Passed Counterfeit Rule, Is NASA Next?
August 15, 2014
4-minute read
NASA recently proposed new legislation to address the growing problem of counterfeit parts in the aerospace industry supply chain. The legislation is part of the NASA 2014 Authorization Bill, which passed the House on June 9 and is awaiting approval by the Senate before moving to the president to be signed into law. If passed, NASA will implement changes required by the law through modifications to the NASA Federal Acquisition Regulation Supplement (NASA FAR Supplement or NFS).
Read More
GIDEP Helps You to “Know Your Part”
July 22, 2014
2-minute read
The Government-Industry Data Exchange Program’s “Know Your Part” campaign promotes this valuable tool to NASA engineers and procurement professionals to ensure that we use the best parts on our spacecraft and technology.
Read More
Stennis Uses Six Sigma Principles to Streamline Audit Processes
July 10, 2014
3-minute read
Stennis Space Center applied Six Sigma principles to integrate and improve audit processes.
Read More
A Look Inside the 2014 Metrology and Calibration Working Group Meeting
June 27, 2014
3-minute read
Metrology and calibration representatives from across the agency gathered at Langley Research Center in Hampton, Virginia, May 5-10 for the 2014 annual NASA Metrology and Calibration Working Group meeting.
Read More
First 2014 EEE Parts Bulletin Now Available
June 24, 2014
1-minute read
Find out what NASA's Electrical, Electronic and Electromechanical community has been up to so far this year in the EEE Parts Bulletin for January-May 2014.
Read More